POLE & PLANK

FLAT FACED MONOLITH UNITS, V SHAPED, TRIANGULAR APPLICATIONS, RIGHT ANGLES AND THREE SIDED PROJECTS ARE ALL POSSIBLE USING POLE & PLANK.

There are 14 extrusions in the range, including round or square posts, a D post and a wall mounted quadrant post. All 3 standing posts have internal ribs which will house a standard bracing bar when required. A reversible infill bar allows all four posts to be neatly closed off.

Three sturdy double sided planks are available in widths of 100mm, 150mm and 200mm. Each plank has a screw port to take a shoulder location pin which when driven home, engages the relevant post. Planks or fabricated panels can slide easily in the post’s channel omitting the need to attach full height slider units which can be difficult to fit on-site.

Header panels are fabricated using a panel plank section (NOV 601) and bracing support bar (NOV 610) which uses VHB double sided tape to produce double sided panels. The budget section (NOV 614), is a cost effective solution for single sided panels using the round post. Units are manufactured in mill finish prior to powder coating and delivered to site for installation flat packed.

MONOLITHS, V SHAPES, TRIANGULAR APPLICATIONS RIGHT ANGLED & 3 SIDED

Our V Carrier (NOV 611) is used with the round post to achieve both V and triangular signs. The Quad slot (NOV 612) can be used for finger posts and is perfect for right angled and 3 sided units or as a middle support for larger signs. Flat faced Monolith signs can be produced using the Box 78 section (NOV 613) and either the D or square posts and can house 2mm thick rigid panels with ample room to backlight.

The Utility Post NOV615 is a versatile profile which can be used for finger posts when incorporating NOV611 V Carrier. M6 Bolt Heads can be slid into any of the 10 channels giving the post a number of options for a variety of uses.

Request a Quote